Anti - Wear Hydraulic Drive System / Hydraulic Motor High Efficiency

Hydraulic motor ,Its used in the Submerged Scraper Conveyor:

The installation of the hydraulic motor

Before installate hydraulic motor, please read the hydraulic drive system installation instruction manual carefully, the installation process should be in strict accordance with the "hydraulic drive system installation operation instruction handbook" in the relevant requirements of the motor parts.

Remember: before installate the hydraulic motor, it must be coupling inner hole and drag on the surface of the axle shaft oil dry, can not lubrication!

When tightening bolts, to avoid two clamping ring not parallel, it needs to be a few position measuring pressure ring gap in the whole process between the gap of differential control within 1 mm.
Locking plate bolts tightened rules:

Before tighten to specified torque value of the bolt (50% of the 490 KNM) before the coupling bolts are diagonal pairs tight, and strictly monitor the gap between the compression ring.

After tighten specified torque value of 50% of the bolt, the bolt signed for tags number, and then set for the specified maximum torque wrench, tighten bolts in sequence. Each bolt each twist 1/4 circle, has been turned to the specified torque values (probably at least need to twist 15 ~ 20 times).

After reaching the specified torque values,it still need confirm all bolt has reached the value.

Torque arm installation should be according to the installation drawing. When the torque arm couldn't insert bearing, can loosen nut, fixed torque arm bearing. After the motor installed, it should be tighten nut again according to the requirements of the torque value size.

Hydraulic power station fixed and pipeline connection:

The power station accordance with the requirements of general arrangement with the bolt first, nut firmly fixed on the bracket, and then according to the connection of the hydraulic drive system installation instruction manual power station between the motor and hydraulic line. At the scene of the tube through the platform place cut holes on the platform. Before starting the system and should check whether all the pipe joint in the process of start all tight, with and without leakage. After the connection of the pipe and according to the requirements of the hydraulic drive system installation operation instruction handbook "to inject N46, anti-wear hydraulic oil tank. Drive system should be paid attention to the installation of the hydraulic line also hydraulic tensioning system piping installation note by the terms and conditions. It is important to note in slag machine again after installation ends for all type of lubricating oil of gear train injection of lubricant regulations.