Tail Tension For Bucket Elevator Conveyor Counterweight Iron Automatic Tensioning Device

The tail tension ,Its material is 45 and Q235,for the Bucket Elevator Conveyor:

Origin: China

Brand: Qingdao Kechengyi

Introduction: the tail tension located at the bottom, it adopted counterweight iron automatic tensioning device, constant tension, tensioning longer journeys.

1. The install foundation must firmly, and shall ensure that the lower section bearing surface in horizontal plane;

2. The central casing connection place should add gasket seal, central chassis centerline should guarantee on the same vertical line;

3. The bucket on the drive sprocket shaft and the lower tension sprocket shaft should be adjusted in a horizontal position;

4. Hopper loaded in the Bucket elevator should not have oblique collision cases happened;

5. Leverage - heavy hammer chain tensioning device is when put a heavy hammer should guarantee the normal work required tension, in order to ensure the tension in the use of institutions have enough tension, installing a tensioning mechanism untapped schedule should not be smaller than 50% of the trip;

6. Hopper on the chain Installated must be strong, the layout is correct, the locking bolt and nut spot welding;

7. Must check whether Bucket elevator on the basis of bending, deformation and tilt, etc.;

8. Bucket elevator installation must be removed after lifting tools used for assembly, after no-load test run, check the reducer, bearing, hopper, chain and various connection place fasteners work situation, found that when a failure must immediately stop, eliminate malfunction;

9. Bucket elevator after load test run, all the faults are removed, until well-functioning, it installed finished;